Ryobi BTS10 - Manual (Page 12)

GENERAL INFORMATION
A
WARNING:
Yourtable saw has a precision built electric motor. It should
only be connected to a power supply that is 120 volts,
60 Hz, AC only (normal household current). Do not operate
this tool on direct current (DC). A substantial voltage drop
will cause a loss of power and the motor will overheat. If
your tool does not operate when plugged into an outlet,
double check the power supply.
ON/OFF SWITCH KEY
Your Ryobi table saw is equipped with an on/off switch key
that, if removed, prevents the saw from being turned on. The
key must be in place to turn the saw on. If the key is removed
during operation, the saw may be turned off but may not be
turned on again until the key is replaced. See Figure 3.
In the event of a malfunction or breakdown, grounding
provides a path of least resistance for electric current to
reduce the risk of electric shock. This tool is equipped with
an electric cord having an equipment-grounding conductor
and a grounding plug. The plug must be plugged into a
matching outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
Do not modify the plug provided. If it will not fit the outlet,
have the proper outlet installed by a qualified electrician.
Improper connection of the equipment-grounding conductor
can result in electrical shock. The conductor having an outer
surface that is green with or without yellow stripes is the
equipment-grounding conductor. If repair or replacement of
the electric cord or plug is necessary, do not connect the
equipment conductor to a live terminal.
A
WARNING:
If an extension cord is used, make sure it is a grounded/
3-prong plug and is adequate to prevent excessive voltage
loss. See Extension Cord Caution on back page.
Check with a qualified electrician or service personnel if the
grounding instructions are not completely understood, or if
in doubt as to whether the too! is properly grounded.
Repair or replace a damaged or worn cord immediately.
This tool is intended for use on a circuit that has an outlet
like the one shown in Figure 9. It also has a grounding pin
like the one shown.
OVERLOAD RESET BUTTON
Your Ryobi table saw features an overload reset button. In
the event that your saw turns off during operation, turn the
saw off and allow the motor to cool down for approximately
3 minutes. Push the reset button and attempt to turn the saw
on again. If the saw does not turn on, turn the switch off and
check all cords for proper connection and retry. If it still does
not turn on, contact your authorized Ryobi Service Center. If
it turns on and then cuts off while you are working, you may
be trying to feed the workpiece too quickly or may be
operating with a dull blade or may be trying to operate on a
circuit providing insufficient voltage.
SPEED AND WIRING
The no-load speed of your saw is approximately 4,800 rpm.
This speed is not constant and decreases under a load or
with lower voltage, A line intended only for lights cannot
properly carry a power toot motor. Wire that is heavy enough
for a short distance will be too light for a greater distance. A
line that can support one power tool may not be able to
support two or three.
Page 12