Chauvet SNAPSHOT LED PAR 38 TRI-B - Manual (Page 13)

4. Operating Instructions
13 9/22/2009 11:10 AM
Menu Map
M AIN F UNCTION S UB -F UNCTION S ELECTION S UB -S ELECTION I NSTRUCTION
7 Color Switching
-
Select between 2 switching and 2 fading
built-in programs
7 Color fading
3 Color Switching
3 Color Fading
7 Color sound active Use the Audio Adjustment
Knob located on the back
of the fixture
Select between 2 sound active programs
3 Color sound active
~ - - Select 3-channel DMX mode (RGB control)
~ - -
Select 7-channel DMX mode: RGB, macros,
run speed, strobe, automatic/sound, dimmer
Red
-
Select between 7 static colors. The display
will read ~
. The colors that each of
these represent are indicated to the left.
Green
Blue
Cyan
Magenta
Yellow
White
~ (default range is ) -
This is the speed range for the 4 switching
and fading built-in programs
Red
~
Combine red, green, and blue to create a
custom, static, color
Green
Blue
DMX Operation
This is the operating mode which will allow for control with an external DMX controller. You must set the starting
address for this mode. If this
is your first time using DMX, then it is recommended that you refer to the “DMX
Primer” section in the “Appendix” of this manual.
1.
Press <MENU> until or appears on the LED screen.
2. Press <ENTER>.
3. Using <UP> and <DOWN>, select the desired DMX address ( ~ ).
Master/Slave
This is the operating mode which will allow
1 fixture to act as the “master” and control all of the other “slave”
fixtures. You must set both the master and the slave(s) fixtures to the correct mode for this operation.
Master Settings:
1. Connect the fixtures with DMX cables, as shown in the “Fixture Linking” section.
2. Use any one of the standalone modes for the master unit. This includes: , , and
Slave Settings:
1. Press <MENU> until or appears on the LED screen.
2. Press <ENTER>.
3. Using <UP> and <DOWN>, set the DMX address to .
It is not necessary to set the master fixture as the first fixture in the daisy chain. It may be any fixture
in the daisy chain. For example: fixture 2, 5, 10 or 12, etc.
Only 1 fixture may be set to master.
Do not connect a DMX controller to the daisy chain for this operating mode.