NordicTrack AUDIOSTRIDER 800 NTEL7706.1 - Manual (Page 6)

While another person lifts the Folding Frame (2),
attach the Rear Stabilizer (3) to the Folding
Frame with two M10 x 93mm Button Screws (82)
and two M10 Curved Washers (99).
Next, tighten the Center Foot (95) into the
Frame (1).
3. Attach the Front Ramp Cover (6) to the
Ramp (5) with four M4 x 16mm Screws (97).
Slide an Ml 0 X 25mm Washer (87) onto an
M10 X 20mm Button Screw (111). Tighten the
Button Screw into one end of the Ramp
Axle (72). Apply a small amount of the included
grease to the Ramp Axle.
Orient the Ramp (5) as shown. Align the lower
end of the Ramp with the welded tube on the
Frame (1). Insert the Ramp Axle (72) into the
Ramp and the welded tube. Then, pull the Ramp
Knob (9), lower the Ramp, and engage the
Ramp Pin (62) in one of the three adjustment
holes in the front of the Frame.
Slide an M10 x 25mm Washer (87) onto an
MIO X 20mm Button Screw (111). Tighten the
Button Screw into the open end of the Ramp
Axle (72).