Engine, Off-season storage, Model 020r – MTD 111-020R000 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

or other matter. If this debris is allowed to accumulate!, it will

invite rust and corrosion, and may cause an uneven dis charge

of grass clippings at the next cutting.

The deck may be cleaned by tilting the mower and sc raping

clean with a suitable tool (make certain the spark plug wire
is disconnected).

ENGINE

Refer to the separate engine manual for engine main­

tenance instructions.

Maintain engine oil as instructed in the separate sngine
manual packed with your unit. Read and follow instructions
carefully.

Service air cieaner every 25 hours under normal conditions.
Clean every few hours under extremely dusty condition s. Poor
engine performance and flooding usually indicates tiat the

air cleaner should be serviced. To service the air c eaner,
refer to the separate engine manual packed with yo jr unit.

The spark plug should be cleaned and the gap resut once
a season. Spark plug replacement is recommendec at the
start of each mowing season; check engine manual dr cor­

rect plug type and gap specifications.

Clean the engine regularly with a cloth or brush. Keep the
cooling system (blower housing area) clean to permit proper
air circulation which is essential to engine performance and
life. Be certain to remove all grass, dirt and combustible debris
from muffler area.

OFF-SEASON STORAGE"

The following steps should be taken to prepare lawn mower
for storage.

1. Clean and lubricate mower thoroughly as described in

the lubrication instructions.

2. Refer to engine manual for correct engine storage in­

structions.

3. Coat mower’s cutting blade with chassis grease to pre­

vent rusting.

4. Store mower in a dry, clean area.

NOTE: When storing any type of power equipment in an un~
ventiiated or metai storage shed, care should be taken to rust­

proof the equipment. Using a light oil or silicone, coat the

equipment, especially cables and all moving parts.

Model 020R

10

Advertising