Assembly instructions – MTD 241-688A User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
LüVVt fi HANDLt-
I
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED:
A.
(1) 5/16" wrench
B.
(1) 3/8" wrench
C.
(2) 1/2" wrenches
PARTS IN CARTON (See Figure 1):
(1) Lower Handle
(1) Upper Handle
(1) Chute Deflector
(1) Deflector
FIGURE 1
I
c-
D .
V
F
G——^
CONTENTS OF HARDWARE PACK:
- A
(See Figure 2)
A.
(2)
Hand Knobs
B.
(2)
Curved Head Bolts
J
C.
(2)
Hex Screws 5/16-18 x 1.25" Lg.
G
D.
(2)
Lock washers for 5/16" Bolts
F
E.
(2)
Hex Nuts 5/16-18 Thread
F.
(5)
Wing Nuts
G.
(5)
Flat Washers
J.
( 1 )
Carriage Bolt 1/4-20 x .62" Lg.
FIGURE 2
NOTE
The right and left side of your Leaf
Blower is determined from operator's
position.
1. Remove the Leaf Blower, hardware pack and all
literature from the carton before discarding carton.
2. Place the lower handle into holes located in '
of Leaf Blower Frame.
FIGURE 3
■3. Secure lower handle to frame with two hex screws
(C), lock washers (D) and hex nuts (E). See figure
3. Two 1/2" wrenches are required.