MTD 24604B User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
HOLES
IN
AXLE
FRONT AXLE
HAIR‘D COTTERS (A)
4. Starting on the right side of the edger, place the
axle through the support arm on the frame. Then
place axle through one wheel so the hub of the
wheel is to the outside of the unit. Next place
axle through spacer (D), the other wheel (hub to
the outside of the unit) and through second
— support arm. See figure 4. Secure with push cap
(E) by tapping it on with a hammer. See figure 5.
It is necessary to hold a block of wood or a
second hammer against the push cap on the other
side of the axle.
FIGURE 4
HAIR PIN
Secure the front wheels and axle in position
using two hairpin cotters (A). See figure 5.
FIGURE 5
6.
Slip the three handle grips (T) on the upper
handles and the engagement handle. They will slip
on more easily if you first soak them in warm,
soapy water.
7.
Assemble the two upper handles to the lower
handle with four carriage bolts (J), lock washers
(K) and hex nuts (L). Tighten only finger tight at
this time. See figure 6.
F IG U R E 6