Tractor, To remove mower (see fig. 22), To install mower – Poulan 139700 User Manual
Page 19: To level mower housing, Service and adjustments
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SERVICE AND ADJUSTMENTS
A
CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
Depress clutch/brake pedal fully and set parking brake.
Place gearshift lever in “NEUTRAL” position.
Place attachment clutch in “DISENGAGED” position.
Turn ignition key “OFF” and remove key.
Make sure the blades and all moving parts have completely stopped.
Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with
plug.
TRACTOR
TO REMOVE MOWER (See Fig. 22)
Mower will be easier to remove from the right side of tractor.
•
Remove mower drive belt from electric clutch pulley
only (See ‘TO REPLACE MOWER DRIVE BELT”
through step removing belt from
electric clutch pulley).
•
Pull retainer springs out of rear suspension trunnions.
Remove rear suspension trunnions from lift brackets.
•
Pull retainer springs from front hinge pins.
•
Remove hinge pins attaching parallel linkto mower and
front axle.
•
Raise lift lever to raise suspension arms. Slide mower
out from under tractor.
IMPORTANT: IFANATTACHMENTOTHERTHANTHEMOWER
DECK IS TO BE MOUNTED ON THE TRACTOR, REMOVE THE
LH. AND R.H. SUSPENSION ARMS AND THE FRONT
SUSPENSION BRACKET.
TO INSTALL MOWER
See “INSTALL MOWER” in the Assembly section of this
manual.
TO LEVEL MOWER HOUSING
Adjust the mower while tractor is parked on level ground or
driveway. Make sure tires are properly inflated (See
“PRODUCT SPECIFICATIONS” on page 3).
If
tires are
over or underinflated, you will not properly adjust your
mower.
SIDE-TO-SIDE ADJUSTMENT (See Figs. 23 and 24)
•
Raise attachment lift lever to its highest position.
•
Measure height from bottom deck curl to ground level at
front corners of mower. Distance “A” should be the
same.
•
If distance “A” needs to be changed, snap out access
hole cover on left side of tractor above footrest.
•
To raise left side of mower, loosen nut “B” and tighten
nut “C”.
•
To lower left side of mower, loosen nut “C” and tighten
nut “B”.
•
When distance “A” is equal, securely tighten nuts “B”
and “C”.
•
Replace access hole cover.
19