MTD Yard-Man 203b - Manual (Page 4)

ASSEME^LY INSTRUCTIONS
IMPORTANT: This unit is shipped WITHOUT GASO­
LINE or OIL in the engine. After assembly, see sep­
arate engine manual for proper fuel and engine oil
recommendations.
NOTE: To determine right and left hand sidet of your
chipper-shredder-vacuum, stand behind the unit, in
the operating position.
REMOVE CHIPPER-SHREDDER-VACUUM FROM
CARTON
Remove staples, break glue on top flaps, or cu t tape at
carton end and peel along top flap to open carton.
Remove loose parts included with unit (i.e., owner's
manual, etc.). Cut along dotted lines and lav carton
down flat. Remove packing material and roll unit out of
carton. Check carton thoroughly for loose parts.
LOOSE PARTS IN CARTON See figure 1.
(1)-Nozzle
(1)-Bag
Wing Nuts
FIGURE 2.
FIGURE 1.
AHACHING THE NOZZLE
Remove three wing nuts from the front of the chipper-
shredder-vacuum. Place nozzle in position over the
three studs. Secure with wing nuts just removed. See
figure 2.
NOTE: The metal tab in the nozzle must depress the
safety switch on the front of the chipper-shredder-
vacuum or the engine will not start.
AHACHING THE BAG
1. Place bag inside of handle assembly. Slip the
opening on the bag over the discharge chute,
making certain it is over the rib on the discharge
chute.
2. Place the four straps on the top of the bag over
upper handle, hooking them on studs.
3. Squeeze the clamp on the drawstring, and pull the
drawstring tight. Release the clamp. See figure 3.
Studs