CH Tech Quad M-module Carrier i4000 - Manual (Page 10)

i4000 - Quad M-module carrier for VMEbus
User Manual
Version: 1.2
AcQuisition Technology bv
P.O. Box 627, 5340 AP
Page 10 of 25 Oss, The Netherlands
3.2. C ONNECTORS
3.2.1. M OUNTING AN M- MODULE
Four M-modules can be fitted on the i4000 carrier board. To plug in a module, position the 2-row 40 pole or
3-row 60-pole M-module interface connector of the module above the 2-row header P1 of the i4000. Then
push the module until the header connector is positioned and press the module with care in its place.
Note: With 3-row M-modules row C of the M-module interface connector is left unoccupied.
The module should be secured in its position using four screws (M3 * 5mm), refer to figure 1 for the positions
of the mounting screws.
Figure 1 M-module mounting screws
Module component side
20
1
Module component side
20
1
Module component side
20
1
Module component side
20
1
Row a b c