Safety 1st Alpha Omega Elite - Manual (Page 13)

23
C. Basic Use
24
5.
6.
7.
Insert Metal Retainer
Through Shell and Pad
Locate buckle’s metal
retainer under the shell.
Rotate metal retainer, then
insert retainer up through
the shell and pad.
Remove Buckle from
Child Restraint
From the top, pull buckle
free from shell and pad.
Locate Buckle’s Metal
Retainer
Fully recline the child
restraint. Reach under the
seat between base and shell.
C-8 Installing Harness System
Install Buckle
Fit the buckle’s metal retainer
through the slot in the seat.
Red button must face out.
Pull buckle’s metal retainer
completely through pad
and shell from bottom
of seat.
1.
continued on next page.
Check Buckle
Pull up on buckle to make
sure it is secured. The
buckle must not pull out.
2.
3. Thread Harness Strap
NOTE: For easier assembly,
remove the harness guides.
See section C-7, step 4.
Thread the harness down
through slot on left side
of plastic shell
(1) and up
through slot on right side
(2) .
NOTE: Make sure sewn
end of the harness strap
loop faces the buckle
before starting.
Take both ends of the
harness and make them
even in length.
NOTE: Make sure harness
tightening strap is between
the harness strap and shell
as shown.
1
2
Thread Harness Guides
on Harness Strap
Slide one harness guide on
each harness strap end.
4.