Garmin Edge 800 - Manual (Page 8)

6 Edge 800 Quick Start Manual
1. Connect the heart rate monitor
module
➊
to the strap.
➊
2. Wet the electrodes
➋
on the back
of the strap to create a strong
connection between your chest and
the transmitter.
NOTE
: Some heart rate monitors
have a contact patch
➌
. Wet the
contact patch.
➋ ➋ ➌ ➍
3. Wrap the strap around your chest,
and connect the strap hook
➍
to the
loop.
The Garmin logo should be right-
side up.
4. Bring the device within range (3 m)
of the heart rate monitor.
TIP: If the heart rate data is erratic
or does not appear, you may have to
tighten the strap on your chest or warm
up for 5–10 minutes.
After you put on the heart rate monitor,
it is on standby and ready to send data.
When the heart rate monitor is paired,
a message appears, and appears
solid on the status page.
installing the GSC 10
NOTE: If you do not have a GSC 10,
you can skip this task.
Both magnets must be aligned with
their respective indication lines for the
Edge to receive data.
1. Place the GSC 10 on the rear chain
stay (on the side opposite the drive
train).
NOTE: Place the flat rubber pad
➊
or the triangle-shaped rubber pad
between the GSC 10 and the chain
stay for stability.