Compatible Systems 2200R - Manual (Page 37)

Chapter 6 - Basic Configuration Guide 31
keywords in the Link Config WAN 0 (and/or WAN 1) section.
SMDS Addressing
Many of these parameters will be given to you by your service provider.
CV: Use the Link Configuration: WAN Dialog Box and select SMDS
from the Link Type pull-down menu. Then click on the SMDS
button to set addresses.
TB: Use configure and set the StationAddress, IPMulticast and
PollingFrequency keywords in the SMDS WAN 0 (and/or
WAN 1) section.
Saving a Configuration File to Flash ROM
Once a configuration is complete, you can save it to the router’s Flash
ROM. Until saved, all changes are made in a separate buffer and the
actual router interfaces run as before the changes were made.
CV: Use the Save to/Device option from the File menu.
TB: Use the save command.