Iii. connect to the water supply – Creda IWM12 User Manual
Page 6
iii. Connect to the Water Supply...
●
Water taps and standpipe should be situated away from the rear of appliance but in easy
access for turning on and off.
●
For your machine to operate correctly it requires water pressures in the range of 6-150 psi
(100 - 1000KPa). Most water supplies will be in this range.
●
Connect the hoses to the water supply pipes at the rear of the appliance
and onto the water supply taps (Red end fitting to the hot water supply
and adjacent to ‘H’ on the rear of the appliance and White end fitting to
the cold water supply and adjacent to ‘C’ on the rear of the appliance).
Remember to insert a sealing washer (A) to ensure each connection is
watertight.
Fit securely and turn on the water supply to check for leaks.
If there is a leak, turn off the water supply, remove the connector
and check that the sealing washer is in place. Refit the connector
and tighten it. Turn on the water supply.
Note: Do not over tighten the water supply pipe connection. Hand
tight should be sufficient.
We recommend you use the new hoses provided with your appliance to ensure correct
connections and prevent leaks.
WARNING
●
Do not connect
appliance to a single
outlet instantaneous
water heater.
6
Remember you may be
charged for a service
call if a problem with
your appliance is
caused by incorrect
installation or misuse.
If the fill hoses are too short:
If you have no hot water supply or your hot water pressure is low:
Longer fill hoses are available from our Genuine Parts and
Accessories Mail Order Hotline
UK on 08709 077 077
(or in the Republic of Ireland on (01) 842 6836).
Remove the existing fill hoses from the inlet valves on the
back of the machine and fit the new longer fill hoses as shown
with the angled ends of the hoses connected to the machine.
A cold fill adaptor and fitting instructions are available from
your local Creda authorised Service Centre or by calling the
Genuine Parts and Accessories Mail Order Hotline
UK on 08709 077 077
(or in the Republic of Ireland on (01) 842 6836).
A cold fill adaptor