Louisville Tin and Stove BFT201 - Manual

BLUE FLAME
VENT FREE HEATERS
INSTALLATION AND
OPERATION INSTRUCTIONS
P/N 88950 / REV. MARCH 2013
WARNING: If the information in this manual is not
followed exactly, a fire or explosion may result causing
property damage, personal injury, or loss of life.
- Do not store or use gasoline or other flam-
mable vapors and liquids in the vicinity of this
or any other appliance.
- WHAT TO DO IF YOU SMELL GAS:
••••• Do not try to light any appliance.
••••• Do not touch any electrical switch; do not use any
phone in your building.
••••• Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
••••• If you cannot reach your gas supplier, call the fire
department.
- INSTALLATION AND SERVICE MUST BE
PERFORMED BY A QUALIFIED
INSTALLER, SERVICE AGENCY OR THE
GAS SUPPLIER.
R
TYPE GAS MODEL NUMBERS
NATURAL GAS BFT101 BFT201 BFT301
PROPANE GAS BFT102 BFT202 BFT302
This appliance may be installed in an aftermarket, permanently located, manufactured (mobile) home,
where not prohibited by local codes. This appliance is only for use with the type of gas indicated on the
rating plate. This appliance is not convertible for use with other gases.
Installation, maintenance, service, troubleshooting and repairs must be performed by a qualified service
agency. MR./MRS. HOMEOWNER, DO NOT attempt any of these procedures yourself as this could
expose you to property damage, personal injury or loss of life and will invalidate all warranties.
This unit is for residential use only and is not approved for installation in greenhouses,or
environments involving dusty, wet, corrosive, or explosive conditions. Such conditions will
invalidate the warranty and may create unsafe conditions.
This is an unvented gas fired heater. It uses air (oxygen) from the room in which it is installed. Provisions
for adequate combustion and ventilation air must be provided. See Pg. 4 & 5.
INSTALLER: Leave this manual
with the appliance.
CONSUMER: Retain this
manual for future reference.
INSTALLER MUST SHOW
HOMEOWNER PROPER
LIGHTING AND OPERATION
OF HEATER. HAVE THEM
COMPLETE AND RETURN
THE WARRANTY CARD.