Clarity C900 - Manual (Page 9)

16 17
INSTALLATION
Tip: To avoid problems caused by forgetting/losing your PIN
code, we recommend that you deactivate the PIN code.
Open the phone and press the
until you have reached
Settings. Next scroll down by pressing the to PIN
Request, press the . At this point, a 4-digit PIN code
will be requested once again.
Enter the PIN code via the keypad and confirm your entry
with .
To return to the standby mode, press
or close the
mobile phone.
Please note: A PIN code deactivation is not possible with
some network providers.
INSERTING THE BATTERY
The battery contacts have to face the gold colored •
contacts of the mobile phone. (Fig.5)
Replace the battery cover back by sliding it with the two
•
hooks in front onto the mobile phone.
Inserting Standard Batteries
Please note the • AAA
symbols at the bottom of
the battery compartment. When inserting ensure the
ends match the corresponding symbols.
Put the battery cover back by sliding it with its two
•
hooks first onto the mobile phone.
Charging the Battery
Important: Charge the battery for at least 4
hours before making your first call. (Fig. 7)
Insert the power plug into the 120V wall outlet. •
Connect the charger to the phone by plugging it into •
the port at the bottom end of the mobile phone.
Fig. 5
Fig. 6
Fig. 7
During the charging phase, the mobile phone screen •
displays the battery symbol and Charging. At the
same time, the signal light flashes orange when there
is a connection between the charging device and the
mobile phone. (This will start about ten (10) seconds after
the connection of the charger to the phone).
As soon as the battery is fully charged, the display
•
shows Battery Full, the orange light will be on and
have stopped flashing.
Now separate the charger from both the mobile
•
phone and the power socket.
Battery and signal strength indication
One bar of the battery status icon corresponds to 25% capac-
ity (4 bars = 100%). If the battery level falls under 25% and
the alert at the bottom of the mobile phone blinks red, please
charge the battery using the charger.
The signal strength is displayed on the right of the screen. If it
is below 25%, the reception and the acoustic quality of calls
are strongly affected. If that is the case, please try to find a
place where the signal is better. (Fig. 8)
Fig. 8
INSTALLATION