Craftsman 486.242241 - Manual (Page 9)

9
STEP 17 - ASSEMBLE HOPPER CLAMPS
• Assemble two hopper mount clamps (T) over the hole
in the middle of each upper hopper tube using two
carriage bolts (F) and two nylock nuts (I). Tighten only
finger tight. See figure 17.
• Fold the bag flaps around the lower hopper tubes and
attach to the bag bottom using the snaps. See figure
16.
FIGURE 16
STEP 16 - ATTACH BAG BOTTOM
• Insert the bag frame strap into the stitched sleeve at
the front edge of the bag bottom. See figure 14.
FIGURE 15
FIGURE 17
CLEVIS PIN (O)
HAIR COTTER
PIN (S)
BAG FRAME STRAP
SNAP
FLAP
BAG FRAME STRAP
STITCHED
SLEEVE
• Assemble the bag frame strap to the holes in the
lower hopper tubes using two clevis pins (O) and hair
cotter pins (S). See figure 15.
FIGURE 14
5/16" x 3/4"
CARRIAGE
BOLT (F) 5/16" NYLOCK
NUT (I)
HOPPER
MOUNT
CLAMP (T)
UPPER
HOPPER
TUBE