Chicago Electric 10" Industrial Tile/Brick Saw 69275 - Manual (Page 15)

Page 15 For technical questions, please call 1-800-444-3353. Item 69275
SAFETY
OPERA
TION
MAINTENANCE
SETUP
Maintenance and Servicing
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool to its “OFF” position, remove the key, and unplug the tool from
its electrical outlet before performing any inspection, maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
Cleaning, Maintenance, and Lubrication
1. BEFORE EACH USE, inspect the general condition
of the tool. Check for loose hardware, misalignment
or binding of moving parts, cracked or broken parts,
damaged electrical wiring, and any other
condition that may affect its safe operation.
2. AFTER USE, wipe external surfaces of the tool
with clean cloth. Also, clean the following after
every use, and as needed during extended use:
• Rails
• Particle Tray (see page 11)
• Water Tray (see page 11,
empty out sediment and water)
• Pump filter and housing (see page 11,
can often be rinsed off without opening pump).
3. If Blade is out of alignment, Table does not
slide smoothly or other issues interfere with
smooth operation, have the saw serviced by
a qualified technician before further use.
4. WARNING! If the supply cord of this
power tool is damaged, it must be replaced
only by a qualified service technician.