Installation – CDA SA116 User Manual

Page 9

Advertising
background image

Installation

Important

If the oven is being installed into a built under oven housing unit ensure that the front rail at the top of the unit is not
installed as it could restrict ventilation.

Ensure that air can flow freely around the housing area. If the oven is being installed into a fully enclosed built-under oven
housing unit it may be necessary to cut a small slot in the top of the plinth fitted under the unit. Cut a section 400mm wide
and a minimum of 15mm high to allow air to pass under the unit. Alternatively cut a section 400 x450mm in the base of
the carcass as indicated.

Failure to allow adequate ventilation to the appliance may result in overheating or damage to adjacent units and could
invalidate the warranty.

This appliance is type X installation.

The walls of the kitchen units must be able to withstand temperatures of 75

o

C above ambient (typically this is between

90

o

C and 100

o

C).

When correctly installed ensure that there is a gap of 4mm minimum between the sides of the oven and adjacent
furniture doors.

Lift the oven carefully into position on the shelf, taking care NOT to lift it by the door handle. If you lower the oven door, you
will see 4 screw holes, 2 on each side of the oven. The oven should then be secured to the housing by fitting screws into these
holes. Remember the housing should not be free standing but be secured to the wall and/or adjacent fittings.

How to install your oven

You will need the following housing area fit your
oven correctly.

The oven is designed to fit into a cabinet of 600mm
width. The oven can be built in or built under
the kitchen units, but you must ensure that it is
properly ventilated. In the diagram the built-in oven
is ventilated by means of a space at the top of the
kitchen cabinet. There are many other methods of
ventilating your oven - Consult a qualified engineer
for advice.

Mueble y caracteristicas técnicas

52 lt

48 lt

48 lt

Volumen útil del horno

212 Statico Rev2 del 3/03 08-04-2005 10:05 Pagina 85

400

560

560

560

450

575

575

100

560

450

499

20-24

598

594

558

573

Características eléctricas

Resistencia grill

1800 W

Resistencia circular

2100 W

Bombilla iluminación

max 25 W

86

fig. 4

Dimensions

Height (mm)

Width (mm)

Depth (mm)

Oven

598

598

515

Housing

575

560

560 (min)

Advertising