Creda IDI60 - Manual (Page 14)

14
D ISHWASHER
Detergent
Detergent specifically intended for use with dishwashers
must be used. The dispenser must be refilled before the
start of each wash cycle following the instructions provided
in the "Programme Chart". The detergent dispenser is
located on the inside panel of the door.
Loading the detergent
To open lid "A", press button "B". The cleaning detergent
should be introduced into the three containers "1", “2”and
“3”. "(see table at the end of the page)
After pouring in the detergent, replace the lid, pressing down
until it clicks.
The rinse aid
This product makes dishes sparkle more as it improves
their drying. The rinse aid container is situated on the inside
of the door, you should refill it when light “D” indicates that
it is empty.
(If your dishwasher is fitted with a “low rinse aid” indicator
light, fill the container up when the indicator light flashes or
lights up).
Loading the Rinse Aid
To open the dispenser, turn the "C" cap in the anti-clockwise
direction and then pour in the rinse aid, making sure not to
overfill. The amount of rinse aid used for each cycle can be
regulated by turning the dose adjuster ‘F’ which you will find
under lid ‘C’.
There are 6 different settings; the normal dosage is setting
5.
To use the Normal or daily wash cycles (See Programm Chart in the instruction booklet)
Load for 12 Standard Settings tests (upper rack at top position)
INFORMATION FOR TEST LABS
EN 50242
IEC/ DIN
Cycle
See booklet
See booklet
Total detergent
30 gr.
30 gr.
Comp.1 Comp.2 Comp.3
25 5
10 20
B
A
Comp1 Comp2 Comp3
C
F
D