Black & Decker 5065 - Manual (Page 2)

Additional Safety
Information For Drills
1. The switch lock feature must be
used 'With caution due to the high
torque output of the tool (See Figure
1 ). , ,
2 . Do not attempt to change from
hammer to drill mode while tool is
running.
Switches
To start unit, depress trigger switch;
to stop unit, release trigger. To lock
trigger in “ON" position for continuous
operation, depress trigger and push in
locking button Figure 1, then gently
release trigger. To release locking
mechanism, depress trigger fully, then
release it. Before using the tool {each
time) be sure that the lock button release
mechanism is v\/orking freely.
Be sure to release the switch
locking button before disconnecting the
?c cause the tool to start immediately
the rex: hr*e *: T c'ugced ;c. Damage or
injury could result
WARNING: The switch lock feature
must be used with caution due to the
high torque output of this unit.
The Variable Speed Trigger Switch
permits speed control. The farther the
trigger is depressed, the higher the
speed of the unit.
For maximum tool life, use lower
speed only for starting the hole. Continu­
ous use at lower speed is not recom­
mended.
The Reversing Lever is used for
removing jammed drill bits, or backing
out screws. It is located above the trigger
switch, as shown in Figure 2. To operate
the tool, in reverse, push the reversing
lever to the right, shown in Figure 2.
When reversing operations are con­
cluded, return the lever to the forward
Dosition, as shown in the figure.
Brushes
Your tool is equipped with Black &
Decker brush checkpoint system. When
the brushes become worn out the tool
will automatically stop and prevent
damage to the motor. Return the tool to a
Black & Decker Service Center for brush
replacement. ^
a ^ {
Stop
Capacity 'I/4" to 1/2" Governs
drilling depth.
Wire Wheel Brushes
Use in cleaning and «'amoving rust,
scale, old paint. 4" Fine Brush, crimped:
Viaximum sate PPM—4,500 4" Coarse
Brush, crimped; Maximum safe RPM—
^O500.
#1
Buffing Wheels
Use with 1/4" to 1/2" Drills and
Wheel Arbors. 3" x 3/8" x 1/2" Cotton
Buff.
è
Rubber Backing Pad
Fit 1/4" to 1/2" Drills. 4-5/8" Rubber
Backing Pad with plain shanK. Used «or
sanding operations.
L
J
»
Wheel Arbors
Fit 1/4" to 1/2" Drills. Carry wire
wheel brushes and buffing wheels.
Sanding Discs
Use with Rubber Sacking Pad.