Aiwa AV-D30 - Manual (Page 10)

BASIC OPERATIONS
SELECTION OF AUDIO/VIDEO
SOURCE
1 Select the program source.
Press one of the function buttons or the TAPE MONITOR
button.
To listen to or watch The button pressed
Tape TAPE MONITOR
Radio TUNER
Record PHONO
Television, etc. AUX
Compact disc CD
Video VIDE0 1/5.1 CH, VIDE0 2,
VIDEOS ,
LD or Cable TV VIDEO 2
MDorDVD VIDEO 1/5.1 CH
The function buttons to be pressed (except PHONO) depend
on the equipment connected to the input terminals on the
rear panel of the unit. '
To change a displayed name for the VIDEO 1/5.1 CH
button and VIDEO 2 button
When the VIDEO 1/5.1 CH button is pressed, VIDEO 1 is
dispiayed initiaily. It can be changed to DVD or MD.
With the power on, press the POWER button whiie pressing the
VIDEO 1/5.1 CH button.
This VIDEO 1/5.1 CH button also works as the 5.1 CH (5.1
INPUT) function switch. Whiie the selected function name
(VIDEO 1, DVD or MD) for the VIDEO 1/5.1 CH button is
displayed, press the button again. The function name wiil change
to “5.1 CH” and the source connected to the 5.1 INPUT terminals
is selected.
To resume, press the button again so that the selected function
name is displayed.
The dispiayed name for VIDEO 2 button can be changed to
(VIDEO 2, LD or TV; with the power on, press the POWER button
while pressing the VIDEO 2 button.
To adjust the sound level of the connected source
The input sensitivity level of each function (except the TUNER
and 5.1 CH functions) can be adjusted.
When the sound level of the connected source is higher or lower
than that of the TUNER, adjust it as follows.
1 Select the function to be adjusted.
Press the function button accordingly and play the source.
2 Press the UPA or DOWNT button repeatedly.
The level can be adjusted between -6dB (MIN) and +8dB (MAX)
in 2dB steps. Adjust the level so that the sound is output at the
same level as the TUNER.
When using a turntable with a built-in equalizer amplifier, set the
switch of the equalizer amplifier to off See the instructions of
the turntable for further information.
2 Start the selected program source.
3 Adjust the Sound.
' The input sensitivity level of the TUNER or 5.1 CH function
cannot be adjusted.
' That of the TAPE MONITOR cannot be adjusted either.
Even if the TAPE MÒNITOR is selected and the TAPE
MONITOR indicator turns red, pressing the UPA or DOWNT
button will change the level of the function displayed on the
window.
About the video source to the monitor or TV
! M ;
VI: VIDEO 1, V2:
Selected VIDEO source
2, V3: VIDEO S
The selected video source is indicated on the display and the
video signal through the MONITOR VIDEO OUT jack is output
on the TV.
9
ENGLISH