AEG LAVMAT BELLA 1003/803 - Manual (Page 13)

Should your machine show grey deposits
of lime, please do not try to remove them
by unsuitable means, but contact your
AEG Service Department instead.
If there is a danger of frost, empty the
machine beforehand of all water by ope­
ning the drain filter. Unscrew the supply
hose and let this drain as well.
What can be the cause
when ...
Non-functioning of your automatic
washing machine is mostly due to the
following which you can rectify yourself.
What is important is that you regulariy
ciean the drain filter.
To do this, place a flat dish on the floor
below the filter outlet bottom left. Next
fold down the lower front panel (where the
machine has been built in, you should use
the plastic hook provided for the purpose)
and give the filter cover about a half a turn
in r ‘’-clockwise direction. The water can
no. .rain off. Unscrew the filter com­
pletely and clean It. When refitting the fil­
ter -^lease ensure that it is Inserted cor-
rei in its guides and securely tigh-
tenpd.
Oc^ .oionally you should also clean the
filter in the water inlet hose.
What may look like rust stains on drum or
tub is due to ferrous foreign bodies intro­
duced with the laundry or the water.
Remove such stains with a stainless steel
cleaning agent. Do not use chlorous or
ferrous scouring powders. Never use
acids, chloride or bleach in the machine.
The programme does not start.
Has the machine been plugged in or
switched on?
Are the fuses in order?
Have the doors of the machin.^ been
closed properly? '
Is button in depressed?^
Too little or no water in coming in.
Has the tap been O/pened?
Has the washing /powder dispenser been
fully pushed home?
Is the filter In thè water supply line
blocked?
It should be cleaned from time to time.
Is'the supply hose kinked?
Is the water pressure too low?
The water is immediately running off
again through the drain hose.
Please note that the discharge end of the
drain hose must not be Immersed In the
pumped-off water (siphon action).
13