Black & Decker HT300 - Manual (Page 3)

MAINTAIN HEDGE TRIMMER WITH CARE - Keep cutting blades sharp and dean (or best performance and to
reduce the risk of injury. Inspect extension cord periodically and replace if damaged. Ke^ handles dry,
dean and free from oil and grease.
CHECK DAAMGED PARTS - before further use of the hedge trimmer, a guard or other part that is damaged
should be carefully checked to determine that it will operate properly and perform its intended function.
Check for alignment of moving parts, binding of moving paiis, breakage of parts, mounting and any other
condition that may affect its operation. A guard or other part that is damage should be properly repaired
or replaced by an authorized service center unless otherwise indicated elsewhere in this manual.
SAFETY WARNINGS: DOUBLE INSULATION
Double insulated tools are constructed throughout with two separate layers of electrical insulation or one
double thickness of insulation between you and the tool's electrical system. Tools built with this insulation
system are not intended to be grounded. As a result, your tool is equipped with a two prong plug which
permits you to use extension cords without concern for maintoining a ground connection.
NOTE; Double insulation does not take the place of normal safety precautions when operating this tool. The
insulation system is for added protection against injury resulting from a possible electrical insulation failure
within the tool.
REPLACEMENT PARTS: When servicing all tools, USE IDENTICAL REPLACEMENT PARTS. Repair or replace
damaged cords.
SAFETY WARNINGS AND INSTRUCTIONS: POLARIZED PLUGS
To reduce the risk of electric shock, this equipment has a polarized plug (one blade is wider than the other).
This equipment must be used with a suitable polarized 2 wire or 3 wire extension cord. Polarized connections
will fit together only one way. Make sure that the receptacle end of the extension cord has large and small
blade slot widths. If the plug does not fit fully into the extension cord, reverse the plug. If it still does not fit,
obtain a suitable extension cord. If the extension cord does not fit fully into the outlet, contact a qualified
electrician to install the proper outlet. Do not change the tool plug or extension cord in any way.
s heod sen
Vsktetephilli;..
Tornillos con (obezo phillips
Actuotor Positions
Positions do Toclionneur
Posiciones del octuodor
ACTUATOR POSITIONS
LOCKED
ON
LOCKED
OFT
Locked On On Locked Off
Verr. en morée En morche Verr. hors tension
Asegurado encendido Encendido Asegurado opogado