Autostart AS-1484 - Manual

To obtain a copy of the complete installation guide,
please visit the http://www.autostart.ca website and
click on the « Download e tab.
http://www.autostart.ca/ Installation Guide
M A N U A L T R A N S M I S S I O N R E M O T E S T A R T E R
AS-1474/AS-1484
Quick Installation Guide
To obtain a copy of the complete installation guide,
please visit the http://www.autostart.ca website and
click on the « Download e tab.
Table of Contents
How to Flash the Hood Pin..................................1
Resetting the Module (without the plug-in valet).. 1
Transmitter Programming Procedure...................2
Entering Programming Options............................2
Programming Options.......................................... 2
Tach Programming...............................................3
How to Flash the Hood Pin
Horn Honk Timing................................................ 3
Supplementary Information.................................. 3
Fifth Relay Output (2nd IGN, ACC or CRANK).... 3
Tach jumper settings............................................3
Testing................................................................. 6
Diagnostics - Parking Light Flash Table............... 7
THE INSTALLER > THE MODULE >
1. Press and hold the hood pin for 4 seconds.
2. Release the hood pin.
3. While the parking lights are on, press down the hood pin once more
and release the hood pin immediately.
4. You now have 20 seconds to select one of the sub-menus
Parking Lights “ON”
“ON” for 20 seconds
Resetting the Module (without the plug-in valet)
WARNING! By resetting the module, all programmed values are erased — i.e.: tach, transmitter as well as
programming options. The programming options are returned to their default values.
1. FLASH the hood pin (see above).
2. In ten seconds or less, press and release the brake pedal 6 times.
The parking lights will flash 8 times confirming the reset.
Notice
The manufacturer will accept no responsibility for any electrical damage resulting from improper installation of the product, be
that either damage to the vehicle itself or to the Unit. This Unit must be installed by a certified technician using all safety devices
supplied. Please note that this guide has been written for properly trained Autostart technicians: a certain level of skills and
knowledge is therefore assumed. Please review the Installation Guide carefully before beginning any work.
Warning
This Remote Car Starter is designed for vehicles with a manual Transmission only. Before installing the Unit, test that the
OEM Door Switch contacts of the vehicle work well, and that the Parking Brake system operates properly.
DOC .4.01 - March 14, 2006 CA SP Manufactured in Canada
P. 8