CLIFFORD III - Manual (Page 12)

Ul traSe cure™ coded valet mode
Your secret valet code
In seconds, thieves can disable all non-Clifford starter interrupt systems and alarms by
hotwiring the ignition and flicking an easy to find “hidden” valet switch. Your Smart
Remote Starter III has safeguards that absolutely ensure that a thief cannot enable the
valet mode as a way of “turning off” your system’s starter interrupt. How? To enable
valet mode, the driver must first enter a secret valet code on the PlainView switch. Your
code will be a 1-to-3-digit number of your choosing. Each digit can be any number from 1
to 9, (i.e. the code can be any number between 1 and 999, except those that contain a
zero). Whenever the system is put in valet mode, it overrides autoactivation of the starter
interrupt (see page 9). At various times, you will need to enable valet mode, such as
when having your car serviced, washed or parked by a valet.
NOTE: If you tem po rar ily lose the use of your re mote con trols, you can over ride
the sys tem’s starter in ter rupt by ena bling valet mode.
Your factory- set valet code is the sin gle digit “2.”
Definitions
Digit: A digit is defined as any number from 1 to 9, inclusive.
Valet code: A valet code may be 1 to 3 digits:
A one-digit code=X=any number between 1-9
A two-digit code=XY=any number between 11-99 (excluding those with zeros)
A three-digit code=XYZ=any number between 111-999 (excluding those with zeros)
Re mem ber, no code can have a zero.
Plain View switch: A rocker switch mounted on the dashboard or console. The
switch has three positions: 1.) Latched 2.) Center 3.) Spring-loaded
momentary. When you press the latched side, the switch remains in its
pressed position. When you press the momentary side, the switch bounces
back to the center position.
En ter ing a digit: To enter a digit, you tap (press and release) on the
momentary side of the PlainView switch the number of times corresponding
to the numeral of the digit to be entered, followed by pressing to the latched
side, then returning the switch to its center position.
En ter ing a code: If your code has only one digit, enter the code as described
in “Entering a digit.” If your code has more than one digit, just repeat the
above for each digit of your code.
10