Bunn BT10 User Manual
Warning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
RI IM M* Protective Shield Installation Instructions
BUNN Home Coffee Brewer Models GR10, B10 and BT10
Warning!
Before attempting to perform any of the following steps,
UNPLUG YOUR BREWER FROM THE ELECTRICAL OUTLET !
The parts pictured below are included in your Installation Kit.
If your kit does not contain all these parts or if you have any questions about installing the shield, please call 1-800-385-2652.
Toolsrequired:
(1) Phillipsscrewdriver
Protective Cover
(
1
)
Screw*
(7)
*Seven screws are included as extra in case you misplace the screws from yourmachine while installing the shield
Perform the following steps to install the protective shield:
Unplug the brewer from
the electrical outlet and allow
the brewer to cool for at least
two hours.
NOTE: It is not necessary to empty
the water in the brewer to install the
protective shield.
Using a Phillips screwdriver, remove the 2 screws from the top
lid of the brewer.
NOTE: The two screws are under the ^ip lid as shown.
O
Remove the top lid by
grasping the ^ip lid and
pullingup. Setthetoplidand
the 2 screws aside.
NOTE: you may notice a build-up
of lime residue in the pour-in bowl
when you remove the lid. This
is perfectly safe & normal, and it
comes from your water source.