Avanti GR-20 - Manual (Page 14)

Conversion of Burner Valves
• Unplug the main supply cord of the range.
• Remove burner control knobs from range by pulling them out.
• Remove the screws on the front surface of control panel.
• Remove two screws located on the bottom surface of control
panel.
• Pull out the control panel.
• Using a small screwdriver, loosen or tighten the screws located
on each valve. If set for LP-Propane gas operation, the screws
must be tightened fully. In the factory setting for Natural Gas
operation, the screws must be loosened by turning them
counterclockwise 3/4 turn.
• Replace the control panel and screws.
• Replace the control knobs. (See Figure 15)
Conversion of Surface Burners
•
Unplug the main supply cord of the range.
• Remove the rings of surface burners.
• Pull up the burner rings with their caps and unscrew the orifices
using a 7mm-spanner socket.
• Use orifices located on the information card in a plastic bag at
lower rear side of the range. In order to choose the required orifice
for particular burner and gas type; see the mark located on orifices
and look at the information card.
• Screw each orifice to proper matching burner.
• Place the burner rings to their original locations. Be careful that the
burner rings are level with the surface of the main top.
• Keep the remaining orifices in their plastic bag for future use. (See Figure 16 and
Table 1)
BURNERS 1 LP GAS NATURAL GAS
RAPID
i
0.92 1.40
SEMl-RAPlD i 0.65 0.97
SIMMER ! 0.50 0.75
OVEN i 0.90 1.32
BROILER* ! 0.90 1.32
Table 1 - Marks on orifices •MODEL DGR-21A ONLY
14