Clarity POWER P400 - Manual (Page 11)

11
Installation
Fig. 5 – Phone base installation for
wall mounting
3. Using the short modular cord,
mount the phone as shown in
figure 6.
4. Set the dial mode switch to T
(tone) if you have touch tone service.
Set the switch to P (pulse) if you
have pulse rotary) dialing.
Fig. 6 – Wall mounting installation
5. Connect the handset cord to the
telephone as shown in figure 3.
6. Lift the handset and listen for a
dial tone.
7. Your P400 phone is ready for use.
Slide-out battery
compartment lid
to access battery
compartment
Insert 9V battery into compartment
in base of phone
Battery
compartment
Press here to
open battery
compartment
C. Battery Installation
To make the visual ringer brighter
install a 9 volt battery.
Fig. 7 – Battery installation