ASA Electronics AOS-33 - Manual (Page 3)

BEFORE INSTALLATION.
1. This system operates Ifom tO Volts DC to 38 volts DC, negative ground.
2. Please install this system according to the instructions in this manual.
3. Do not disassemble the camera or the monitor. This voids the warranty Disassembling the camera will
compromise the waterproof sea!
4. Connect the system to an ignition switched power source. Connection to a battery source will reduce battery life.
♦•WARNING**
V To prevent electrical shock, DO NOT OPEN THE KlONlTOR CASE. There are potentiaHy lethal voltages inside the
monitor. There are no user serviceable parts inside. If evidence of tampering is detected, the warranty will tJe
considered void.
2. Keep monitor away from leaking water, rain, moisture etc, It is NOT waterproof. Any moisture inside the monitor
could cause extensive damage.
3. Use the thumbscrews to mount the rnonitor to bracket.
**CAUTION**
1. DO NOT OPEN THE CAMERA CASE. This will break the camera's waterproof seal If evidence of tampering is
detected, the warranty wilt be considered void.
2. Do not mount the camera near the lower area of the vehicle (e g. Bumper). This reduces the view of the camera
and may cause physical damage to the camera.
3. Use only the M4x8 bolts and washers to mount the camera
INSTALLATION INSTRUCTIONS
AOC-rS CAMERA
t. Attach camera bracket (Sec Fig 1} to upper pordoft of vehicle. Attachment point must be sturdy enough to support
camera and bracket,
2- Attach camera to bracket using M4x8 bolts provided. Adjust angle as indicated in figure 2 (Use rear bumper and
back of vehicle as a reference point,
3. \Nthd dettectoT may be mstatted. This detiectov is designed to reduce the bviiid up ot dust, dirt and moisture
on the camera lens (See F)g 3).
AOM-rO MOMTOK
1. Attach monitor inside vehicle in a location convenient to the driver (e.g. center of dash, overhead or in dash). (See
Fig 4)
2. Use a compression plate to attach the monitor bracket to the dash or overhead (See Fig 4).
3. Adjust mounting angle of the monter to allow driver lo easily view the screen from all seat positions (See Fig. 5).
4. If necessary, snap sun visor into groove on front face of monitor. Press all (4) sides of the visor to snap it into place.
AO$'33 Operations Manual
AOC'80 CABLE
Í.
3.
4.
The camera-to-cable connection is waterproof. The cab)e-to-monitor connection is not waterproof. Be sure to
orient the cable properly. The cylit>drical end attaches to the camera. The rectangular box end attaches to the
monitor. (See figure 6)
Do not run the AOC-80 cable over sharp edges or corners. Do not kink the cable. Keep the cable away from hot
and rotating parts.
Place all excess cable in convoluted tubing.
Wire tie the cable securely.
Pane 2 of 14