Black & Decker WM2000 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
LARGE CAPACITY CLAMPING PRESS AND
90° VICE ADJUSTMENT
The swivel vice jaw can be locked in six
different 90° positions 3 front facing and 3
rear facing.
To position the swivelling vice jaw at 90°
remove the wing nuts (A) and hexagonal
nuts (C) and rotate cam lock (B) clockwise
through 45°.
Remove swivel vice jaw and reposition in
one of the above 6 positions. Secure the
swivel vice jaw following the above
procedure in reverse order.
Note: remember to use the swivel jaw
clamping press location holes (D) fig. 1.
Fig. 7 shows the centre board between the
two bottom cross frames as described in
fig. 4. Allowing for greater clamping
capacity.
NOTE: The adjustable vice jaw should
be removed or placed at the end of the
parallel rails.
Fig. 7