Routine maintenance, Cleaning the interior, Cleaning the exterior – Arctic Air 297283501 User Manual
Page 6: Condensate pan, Interior light
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Adjustable Temperature Control
The adjustable thermostat control is located on the top
left panel inside the unit.
Interior Thermometer
The appliance comes with a thermometer to show the
internal temperatures. The thermometer is to be hung
from the top adjustable shelf on the right hand side.
Routine Maintenance
Cleaning the Interior
Be sure to turn the temperature control to “OFF” and
unplug the electrical cord. Wash the inside surface of
the storage area with warm water and baking soda
solution (about one tablespoon of baking soda per
quart of warm water). Rinse thoroughly with clean,
warm water and wipe dry. The procedure can also be
used for cleaning the door gasket. Wipe the stainless
steel cover plates with Magic Clean Stainless Steel
Cleaner (can be ordered from your Artie Air Service
Center at 1-800-490-9574, P/N 218490900) or some
other stainless steel cleaner.
Cleaning the Exterior
Wipe the textured cabinet exterior occasionally with a
cloth dampened in mild detergent and water. Rinse
and wipe dry with a soft cloth. Wipe the stainless steel
door plate and toe grill with Magic Clean Stainless
Steel Cleaner or some other stainless steel cleaner.
Do not use razor blades or other sharp instruments
that can scratch the appliance surface when removing
adhesive labels. Any glue left from the tape can be
removed with a mixture of warm water and mild
detergent or touch the residue with the sticky side of
tape already removed. DO NOT REMOVE THE
SERIAL PLATE.
Condensate Pan
The condensate pan is in a fixed position and must
not be removed from under the cabinet. If the pan is
removed, condensate will drop onto the floor.
Interior Light
• The Glass Door Refrigerator is equipped with a 17
watt fluorescent lamp. Ballast - lamp mismatch may
result in poor or no performance.
• If the lamp fails, replace with a lamp of the same type
and wattage. Also, replace a lamp that flickers
continuously. This could damage the ballast.
• Turning the light off, when not in use, will save
energy. However, frequent CN-CFF cycling will
reduce the lamp life.
• Use only NSF certified lamp (216659500) which can
be ordered from your Artie Air Service Center by
calling 1-800-490-9574.