Arcam Delta 70.2 - Manual (Page 12)

General
Width 430mm
Height 90mm
Depth 272mm (drawer closed and excluding rear panel
connectors), 410 mm (drawer open and excluding rear panel connectors)
Delta 70.2 Weight 5.25kg Net Delta 170 - 5.25kg Net
Weight 6.3kg Packed - 6.5kg Packed
(inc. sorbothane feet)
Guarantee for UK sales
This equipment has been fully tested and a full record of
these tests made before despatch from the factory. Both the
workmanship and the performance of this equipment are (except as set
out below) guaranteed against defects for a period of two years from the
date of purchase provided that it was originally purchased from an
authorised UK dealer under a consumer sale agreement. (The words
'consumer sale' shall be construed in accordance with Section 15 of the
Supply of Goods (Implied Terms) Act 1973).
The manufacturers can accept no responsibility for defects
arising from accident, misuse, wear and tear, neglect or through
unauthorised adjustment and or repair, neither can they accept
responsibility for damage or loss occurring during transit to or from the
person claiming under this guarantee.
This guarantee covers both labour and parts and it is transferable to
subsequent purchasers but the liability of the manufacturers is limited to
the cost of repair or replacement (at the discretion of the manufacturers)
of the defective parts and under no circumstances extends to
consequential loss or damage.
Claims under this guarantee
This equipment should be packed in the original packing and
returned to the dealer from whom it was purchased or, failing this, any
other authorised Arcam dealer. If it is not possible to return the
equipment by hand, then It should be sent carriage prepaid by a
reputable carrier.
Should the original packing not be available, replacement
packing can be purchased from the manufacturers. The equipment should
not be sent by post.
Do NOT CONSIGN THE EQUIPMENT TO A8R CAMBRIDGE UNLESS YOU HAVE
FIRST BEEN SPECIFICAaV REQUESTED TO DO SO BY THE MANUFACTURER'S TECHNICAL SERVICE
DEPARTMENT. Do NOT UNDER ANY CIRCUMSTANCES ATTEMPT TO DISASSEMBLE THE
EQUIPMENT BEFORE DESPATCH.
If you have any difficulty complying with these requirements
please contact the manufacturers at the following address.
A&R Cambridge Limited,
Pembroke Avenue,
Denny Industrial Centre,
Waterbeach,
Cambridge CB5 9PB, England.
Telephone: (0223) 440964
Fax (0223) 863384
In either case you should state clearly your name and
address, the date and place of purchase together with a brief description
of the fault experienced.
In the event of equipment being returned which on test is
found to comply with the published specification the manufacturers
reserve the right to charge a reasonable fee for testing the equipment
and for return carriage.
Enquiries
The manufacturers are happy to answer any queries you may
have regarding the use of this equipment on the condition that this
enquiry is by letter and a stamped addressed envelope is provided. You
should state clearly the serial number of the unit, the dealer from whom
it was purchased and the date of purchase.
T his guarantee in no way varies or removes a purchaser s
STATUTORY RIGHTS.
PART NO. SH026A E&OE APRIL 1989