Bolens 139-402A User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
4. Fasten the tubing assembly to the steering
shaft assembly with hex screw and hex nut
provided.
Steering Wheel Cap
Hex Nut
Belleville Washer
Steering Wheel
Cover
Hex Screw
Steering Tube
Assembly
Hex Nut
Steering Shaft Assembly
Speed Nut
Flatwasher
Upper Hex Bearing
Lower Hex Bearing
FIGURES.
7. Secure cover to support bracket with two
truss machine screws provided. See figure 4.
FIGURE 1. STEERING ASSEMBLY
FIGURE 2. STEERING TUBE ASSEMBLY
FIGURE 4.
8. Place the steering wheel on the tubing
assembly and fasten with belleville washer
and hex nut. See figure 1.
5. Place two speed nuts on support bracket, as 9. Again, it may be necessary to raise the
shown in figures.
steering shaft assembly in order to put the
hex nut on.
6. Place the cover over the steering tube
assembly, line up holes in cover with speed 10. Place the steering wheel cap on by hand. See
nuts. See figures.
figures.