Bolens TMO-3394704 - Manual (Page 8)

6 .
Route the drain tube through the opening
between the transaxle reinforcement bracket and
the frame on the left rear of the unit. Insert the
drain tube to the transaxle reinforcement bracket
through the cable tie which is attached as shown
in figure 4. Be certain drain tube is routed away
from the wheel rim. Trim excess end of cable tie
and drain tube (leave approximately 1” below
lawn tractor frame).
Close the top of the battery box.
Steering
Wheel Cap
Steering etaari««
Wheel Steering
Bellow
AHACHING THE STEERING WHEEL (Hardware B)
1. Attach one end of steering bellow to the steering
------wheel as shown in figure 5, inset.
With the wheels of the tractor pointing
straight forward, place the steering wheel and
steering bellow over the steering shaft, position­
ing steering wheel as desired.
Place the washer with the cupped side down over
the steering shaft. Secure with 5/16" hex lock nut.
See figure 5.
Place the steering wheel cap over the center of
the steering wheel and seat it with your hand.
2 .
3.
FIGURE 5.
AHACHING THE CHUTE DEFLECTOR
1. Remove the truss machine screws, cupped wash­
ers and hex jam nuts which are attached to the
deck next to the chute opening.
2. Place the chute deflector in position as shown in
-fioure 6 Secure with hardware rjst removed
▲
WARNING: Do not operate your unit
unless the chute deflector has been
properly installed.