To stop engine, Adjustments, Carburetor adjustment – Bolens 692 and 693 User Manual

Page 4: Two-way discharge, Height adjustment, Maintenance, Lubrication, Engine

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

TO STOP ENGINE

1. To stop engine, move throttle control lever to OFF

position.

2.

Disconnect spark plug wire and ground to prevent

accidental

starting

while

equipment

is

un­

attended.

ADJUSTMENTS

CARBURETOR ADJUSTMENT

A

WARNING: Do not at any time make any
adjustment to the unit without first stop­
ping engine and disconnecting spark

plug wire.

TWO-WAY DISCHARGE

The leaf blower can be adjusted to discharge toward
the front of the unit or to the side. Simply push down
on the handle and swing door toward the front to dis­

charge out the side, or to the side to discharge out the
front. See figure 5.

Directional

Discharge

FIGURE 5.

HEIGHT ADJUSTMENT

The height adjustment crank is located on the right

hand side of the leaf blower. See figure 6. Turn the
crank clockwise to raise the discharge chute. Turn the

crank counterclockwise to lower.

A

WARNING: If any adjustments are made
to the engine while the engine is running
(e.g. carburetor), keep clear of all moving
parts. Be careful of heated surfaces and
muffler.

Minor carburetor adjustment may be required to com­

pensate for differences in fuel, temperature, altitude
or load.

NOTE:

A dirty air cieaner will cause engine to run

rough. Be certain air cleaner is clean and attached to
the carburetor before adjusting carburetor.

Do not make unnecessary adjustments. Factory set­

tings are satisfactory for most applications and condi­

tions. If adjustment is needed, refer to the separate

engine manual packed with your leaf blower.

MAINTENANCE

A

WARNING: Always stop engine and dis­
connect spark plug wire before cleaning,

lubricating or performing any repairs or
maintenance.

FIGURE 6.

LUBRICATION

Wheels-Rear wheels are provided with light oil bear­

ings. Place a few drops of SAE 30 oil on each bearing
once a season.

Directional Discharge-Lubricate the

spring and

the

pivot point on the door mechanism at least once a
season with light oil.

ENGINE

Refer to the separate engine manual for engine
maintenance instructions.

Maintain

engine oil

as instructed in the separate

engine manual packed with your unit. Read and follow
instructions carefully.

Service

air cleaner

every 25 hours under normal con­

ditions. Clean every few hours under extremely dusty

conditions.

Poor

engine

performance

and

flooding

usually indicates that the air cleaner should be ser­

viced. To service the air cleaner, refer to the separate

engine manual packed with your unit.

The

spark plug

should be cleaned and the gap reset

once a season. Spark plug replacement is recom­
mended at the start of each season; check engine

manual for correct plug type and gap specifications.

Clean the engine

regularly with a cloth or brush.

Keep the cooling system (blower housing area) clean

to permit proper air circulation which is essential to
engine performance and life. Be certain to remove all
dirt and combustible debris from muffler area.

Advertising