Crosley Radio CR 712 - Manual (Page 8)

6 7
After reading display CD TOC reading display
Basic Operation
Functions (cont.) Power Up Your Crosley
Your new Crosley is equipped with a POWER /
STANDBY button. Press the POWER / STANDBY
button on either the front of the unit or on your remote
control. The Standby light will turn from red to green.
When turned off, the standby light will turn red.
During standby mode, all presets will remain
programmed in your unit.
Functions
Electronic Volume Control
1
Press the VOL+ button to increase the volume.
The volume level will be shown in the LCD
display.
2
Press the VOL- button to decrease the volume.
3
Press and hold either the VOL+ or the VOL-
button to continuously increase or decrease the
volume. The volume will continue to increase
or decrease until the button is released.
4
Press the MUTE button to set the volume to 0.
Press the MUTE button again to return to the
previous volume level.
Function Select
1
Press the TUNER button on remote to enable
the AM/ FM tuning function. When in tuner mode,
the LCD will display the band (AM/FM), and the
station frequency.
2
Press the CD button on remote to set to CD
mode. When first set to CD mode, the display
will search for CD and track information.
3 Press the PHONO button on remote to set to
phono mode. When in phono mode, the display
will read “LINE”.
Equalizer
1
Your radio has a built in equalizer. The equalizer
fine tunes the sound according to the type of
music you like. Pressing the EQ button results
in the following changes:
Getting Started
Set Up Unpacking
1
Remove packing materials from unit.
Note: Save all packing materials.
2
Remote control is located in the outside of the
styrofoam packaging.
3 Remove plastic bag covering radio and remote
control.
4
Remove plastic safety cover from A/C plug.
5
Remove tie from A/C cord and untie antenna
wire on back of radio.
6
Open lid and remove styrofoam shipping
material from turntable.
7 Remove black tie-wrap from under the tone
arm.
8
Remove white protective needle cover by gently
pulling towards the front of the unit.
1
Install 2 AAA batteries (not included) in remote
control.
2
Plug A/C cord into appropriate outlet.
Note: This product may be equipped with a
polaized alternating-current line plug (a
plug having one blade wider than the
other.) This plug will fit into the power
outlet only one way. This is a safety
feature. If you are unable to insert the plug
fully into the outlet try reversing the plug,
if the plug should still fail to fit, contact
your electrician to replace your obsolete
outlet. Do not defeat the safety purpose
of the polarized plug.
3
Untie the FM antenna and allow it to hang down
in a straight line for optimum FM reception. If
you have trouble tuning in an FM station, move
the external FM antenna for best reception. Do
not connect FM antenna to outside antenna.
AC
Polarized Plug
ELectronic volume control display
PHONO
Phono display
Receiving tuning frequency display
FM Antenna
TACK
ROCK
Equalizer “ROCK”
FLAT ROCK Jazz
CLASSIC POP