Computer Expressions 38CG - Manual (Page 4)

4
PROGRAMMING TIME PERIODS — The duct free sys-
tem can be programmed to operate at desired levels. Be sure to
set the clock before programming the system.
• Increments of time are in 10 minute intervals.
• The Timer Start/Stop indicator light on the unit is on
when a time period is set. See Fig. 4.
• The remote control displays the Start/Stop time of the
time period that is closest to the current time. If the unit
is ON, “STOP” and the time period is displayed. If the
unit is OFF, “START” and the time period is displayed.
Setting Start/Stop Time — Timer feature is used to set unit
operation Start/Stop times. Three different time periods up to
10 hours apart and within 24 hours can be programmed using
this feature.
1. Slide down front cover of controller below ON/OFF but-
ton. See Fig. 4.
IMPORTANT: Be sure to point the remote control
toward the unit while pressing the TIMER or SET
buttons.
beep
II II I I I I I I I II II II I
M O D E
FA N
S W E E P A
A
S T A R T S T O P 1 2 3 S L E E P
D A IL Y
UNIT
REMOTE
TEMPERATURE SENSOR
TRANSMISSION INDICATOR
LOW BATTERY INDICATOR
UP/DOWN BUTTON
DESIRED TEMPERATURE
SENSOR ACTIVE INDICATOR
SWEEP INDICATOR
ON/OFF BUTTON
CLOCK BUTTON*
ROOM TEMPERATURE BUTTON*
DELAY BUTTON*
LOCAL SENSING BUTTON
INFRARED SIGNAL TRANSMITTER WINDOW
CLOCK
TIMER START/STOP
ONE-TIME/DAILY INDICATORS
MODE BUTTON
OPERATION MODE INDICATORS -
COOLING, FAN, HEATING,
DEHUMIDIFICATION, AUTO
FAN INDICATORS -
LOW, MEDIUM, HIGH, AUTO
TIMER SET BUTTONS*
SLIDE DOWN PANEL
II II I II I I I I I I I II II
MODE FAN SWEEP
A A
S TA R T
S TO P
1 2 3 S L E E P
D A I LY
TIMER
SET
CLEAR
DELA
Y
SENSE
ROOM CLOCK
II II I I I I I II I II II II M O D E FA N S W E E P A A
S T A R T S T O P 1 2 3 S L E E P D A I L Y
Fig. 4 — Remote Control
*Buttons located behind slide down panel.
II II I II I I I I I I I II II
MODE FAN SWEEP
A A
S TA R T
S TO P
1 2 3 S L E E P
D A I LY
TIMER
SET
CLEAR
DELA Y
SENSE ROOM CLOCK
Fig. 5 — Location of Clock Set Button
on Remote Control