Chicco 455 - Manual (Page 12)

Page 12 Caboose Ultralight Instruction Manual
Using the Stroller as an Infant
Car Seat Carrier
• To use the stroller to carry an infant car
seat carrier, you must replace the Front
Tray with the Car Seat Carrier Support.
• Remove the Front Tray by pressing in on
the lock tabs and pulling the tray off the
brackets. Store the tray in a convenient
place for later use.
• Line up the female fittings on the Car
Seat Carrier Support to the male fittings
on the front of the stroller and push
inward until the fittings snap into place.
See Figure 25. Pull outward on both
sides of the support to be sure both are
snapped securely in place.
• Push the canopy to its most rearward
position.
• ADJUST THE SEATBACK TO ITS
RECLINED POSITION.
• Remove the infant carrier from the car
seat base.
• Place the infant carrier onto the top of the
stroller in a REAR FACING POSITION,
locating the head end of the carrier
so that it rests on the Car Seat Carrier
Support and the feet end of the carrier
so that it rests on the seatback, but
NOT on the top edge of the seatback.
See Figure 26.
• Ensure that the head end of the infant
carrier is pushed down firmly INSIDE the
frame of the Car Seat Carrier Support
and that it is centered side to side.
• Remove the carrier restraining straps
from the pouches on both sides of the
Figure 25
Figure 26
Figure 27
stroller. Buckle them in place over the LOWEST part of the carrier sides. Adjust the
straps so they are tight around the carrier but AWAY from the child’s neck. Pull up on
the carrier to be sure it is held on securely. See Figure 27.
• Always check frequently to be sure that the restraining straps are tight across the
infant carrier but away from the child’s neck.
• When you remove the infant carrier from the stroller, always replace the two restraining
straps back into their side pouches.
!
WARNING
ALWAYS install the infant carrier so that the child is facing toward the rear
(handle) of the stroller with the restraining straps secured.