Attaching snow thrower to tractor – Bolens 19967-1 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
NOTE
Belt must be assembled as shown in
figure 17. Top of belt goes over drive
pulley and under idler pulley then
twist belt to the left. The bottom of
the belt goes to the right. If the belt is
assembled incorrectly, the spirals will
run in reverse.
DRIVE SHAFT
(FEMALE END)
ATTACHING SNOW
THROWER TO TRACTOR
NOTE
Universal drive shaft is not included
with snow thrower attachment. It is
included with the cutting deck. If you
do not have a cutting deck, order part
number 717-0135.
1. Slip female end of drive shaft over shaft of right
angle drive. Make sure key way is in shaft.
Tighten set screw with 3/8" open end wrench.
See figure 18.
FIGURE 18
Slip male end of drive shaft over tractor P.T.O.
There are two set screws. Tighten both with 3/8"
open end wrench. See figure 19. Tractor was
elevated for photo clarity. Tractor does not have
to be raised to install drive shaft.
FIGURE 19
10