Coleman 2600 Series - Manual (Page 6)

Match Light
Lantern
D Push lighted match
through lighting hole,
hold near mantle and
open fuel valve fully.
(Fig. 22)
Battery
INSTASTART™
Electronic
Ignition Lantern
D Push ignitor button
and hold; then turn
fuel valve on. (Fig. 21)
CAUTION
• SERVICE SAFETY
• Keep all connections and fittings clean.
Inspect propane cylinder and lantern propane
connections for damage before attaching.
• During set up, check all connections and
fittings for leaks using soapy water. Bubbles
indicate a leak. Never use a flame.
Fig. 22
Fig. 21
WARNING
• BURN HAZARD
• Never leave lantern unattended when hot or
in use.
• Keep out of reach of children.
NOTE: If lantern does not light, repeat above step
after turning fuel valve completely off. If the
lantern is wet due to rain, high humidity, etc., the
ignitor may not spark. Use match lighting
procedure as follows.
D Brightness may be
adjusted with
fuel valve. (Fig. 23)
Fig. 23
To Turn Off
D Make sure lantern is cool.
D Move lantern away from flame (including pilot
lights) and other ignition sources.
D Fold feet on lower carry case. (Fig. 26)
D Turn fuel valve
off. (Fig. 25)
To Store
Fig. 25
To Light
WARNING
If you smell gas:
1. Do not attempt to light appliance.
2. Extinguish any open flame.
3. Disconnect from fuel supply.
4. Call 1-800-835-3278.
WARNING
• Replace any mantle with a hole in it. A hole
can cause lantern to overheat and create a
hazard. Never operate lantern without
heat shield.
Fig. 26
Fig. 27
D Unlock the lower carry case and remove from
the upper carry case. (Fig. 27)
Fig. 24
D The lantern may be
carried by the
handle. (Fig. 24)
English-5