American Dynamics LIRC0308CS - Manual (Page 2)

AMERICAN"
DYNAMICS
SPECIFICATION
»Specifications are subject to change without notice.
IR lens
Model LIRC0308CS LIRC2811CS LIRC1040CS
Imager Size 1/3"
Focal Length 3-8mm 2.8-llmm 10-40mm
Aperture FI .0-360 FI.4-360 FI.4-360
Angle of view
(Horizontal X Vertical)
Wide 90.8° X 66.6° 97.4°x72.4° 27.6 °x20.4°
Tele 36,2 x27.0° 26.2°xl9.7° 7.0°x5.3°
Back Focus(in air) Wide: 8.36mm Tele: 14.12mm 8.66-18.69mm 18.61mm-12.17mm
Mount Type cs
Dimensions(nim) 33x40.2 40x54.6 39x67
Operation Voltage(V) Open: 4.0V Close: 0.7V Open: 3.3V Close: 0.7V Open: 3.0V Close: 0.5V
AMERICAN DYNAMICS Safety Precautions
These precautionary statements are classified into two levels of danger depending on the content and grade of elements that comprise the product.
A If the user does not obey these instructions A If the user does not obey these instructions
/f\ and misuses the product, serious injury or /t\ and misuses the product, serious injury and/
Warning !
loss of life may occur.
Caution !
or property damage may occur.
The foilwing symbols are used in these precautionary statements.
A
Shock !
This symbol warns that an electrical
current is present and electric shock
may occur.
®
Do not !
This symbol means that you should not
disassemble the product.
Fire!
This is a fire hazard symbol that means
these is the possibility of igniting fire.
O
Direction !
This symbol means that you should pay
attention to certain handling procedures.
WARNING
Doni disassemble the unit or try to put ^y
foreign substance in it, especially metal of
flammable matter. Doing so could cause yA
electric shock and/ or fire. Don't scratch, open, twist or heat the
connector cable because doing so many
cause fire and/or eiectric shock. A\ Don’t attempt to use product it you subject —. ^
something isn’t right as in seeing smoke or
detecting a strange smeli. if you use the y.
product under these conditions fire and/ or
nK
electric shock could occur.
If the connector cable is cracked or ^
damaged, piease exchange It by writing to QO
with an exchange request. If you .
continue to use the damaged cable, fire
and/ or electric shock may result.
Please keep the unit away form water, if yA
water should get inside the unit, stop using
ifS\.
immediately, otherwise electric shock yA
and/ or tire may occur.
Don't look through the lens directly at the
sun since this could cause blindness.
Don't place the unit near extreme heat,
flame or gas since combustion may occur
resulting in fire. Don't try to repair the unit or any power
source since that may cause fire and- or
eiectric shock. Keep the product out of the reach of
children. If the product fell on a child, injury
could occur.
CAUTION
Don’t place the product in locations with
extremely high or low temperatures. Don't use
the product in areas that are hotter than 60
degress Centigracte or colder than - 10 degrees
Centigrade. Such extremes will effect the
quality performance of the product and could
damage it.
Don't plug in or pull out the csi)le to or from an /C\
electrical outlet with wet hands. This may result
in electric shock.
When attaching frie lens to the camera body,
make sure you grip it securely to avoid the
possibility of the lens falling and becoming
damage.
Don't point the lens directly at the sun or other
strong light since that could damage the image
sensor (Ml the camera and result in poor image
quality.
When storing the lens, keep it out of direct
sunlight. Fire could occur as a result of the light (\)
being reflected off the lens onto a flammable
^
substance.
Don’t drop or hit the product forcefully. This XN
may cause product performance failure.
Don't place the connector cat^e next to a
heater since it could melt and cause fire
and/ or electric shock. Doni place in dusty and humid place. Fire
and/ or electric shock may occur.
A
Don't place the product near a stove or a
humidifier or any place where Oiere is high
heat or moisture. Fire and/ or electric
shock may occur.
à.
If you going to connect the product with
aonther product, please read the connection
instructions
from both product manuals
carefully before attempting any connection.
Otherwise damage may result to one or both
products.
If you going to use a lens that has a tripod
mount but are using a camera body that is
heavier than the lens, please use the tripod
mount on the camera. Failure to do so coukJ
result in severe damage to the lens.
8200-0843-01 AO