Beko D 6623 T - Manual (Page 20)

Maintenance and cleaning
Turn off the mains switch before cleaning
* Before switching on again ensure that all controls are in the OFF
position.
* Make sure that the oven, grill and burners are sufficiently cool
before you start cleaning.
* Your product is manufactured in a manner that it should not
overflow the oily food juices under the counter. The pan supports
can easily be removed and the top burner plate can be cleaned with
soapy water, and rinsed with a dry cloth.
* Wash and rinse the gas burner caps and the pan supports with
soapy water.
Never wash the gas burner caps and the pan
supports in the dishwasher.
For the dirts and stains on the burner
heads that can not be cleaned, use the metal surface cleaners you
can obtain from the market according to their instructions.
* It is recommended that the acidic matters such as oil, lemon etc.
should be cleaned immediately.
* Use a damp cloth to clean the interior and
exterior. Never use any sharp instruments,
abrasive household cleaner, or detergents
for cleaning. For hard stains use
suitable washing liquid.
* Ensure that the door seal is dry after
cleaning. We recommend that grill
elements be wiped with a damp cloth
to remove any fat splashes. This will
prevent fumes for any fat being
burned off when the cooker
is next used.
Vitreous enamel hob surround
Clean with a cloth wrung out in soapy water. Stubborn
stains can be removed with a cream, paste or liquid
cleaner. Check that the cleaning agent used is approved
by the Vitreous Enamel Development Council.
* Never clean the cooker surface by using materials such
as hurd brushes, steel pads or knives, which can easily
scratch the enamelled and stainless steel surfaces.
* Special cleaners that are commercially avaible may be
used after carefully reading the warning labels written
on them. Do not use cleaning agents containing acid or
chlorine.
Cleaning can be accomplished using a soft piece of cloth
wetted with soapy water or with commercially available
special surface cleaners and a soft piece of cloth. Especially
use liquid paste or cream type cleaners.
Control panel
Wipe over the control panel with a damp cloth and polish
with a dry cloth. Do not use oven cleaners or aerosols,
scouring pads or abrasive powder for cleaning
the plastic knobs as damage will occur. Do not attempt
to remove any of the control knobs from the panel as
this may cause damage and is a safety hazard.
1 7