Autostart AS-6850VTW-FM - Manual

□ Idle mode. Make sure the vehicle properly enters and exits idle mode.
□ Door and Trunk trigger. Make sure that when the system is armed, opening any door or opening the trunk will
trigger the alarm (if installed).
□ Hood trigger. Make sure that when the system is armed, opening the hood should trigger the alarm.
□ Shock and warn-away trigger. Make sure that the shock works well and is not too sensitive so that it
unnecessarily triggers the alarm.
□ Most comebacks are the result of misunderstandings about how a product works or performs. Take the
time to properly explain all functions and features to the customers before they leave the premises.
Doing this will save time and money.
Diagnostics - Parking Light Flash Table
Flashes Descri ption
1
• Doors locked, alarm and starter kill armed
• Run time has expired
• TRUNK button pressed
• Start signal received by the module
• Cold weather mode cancelled
2
• Remote start attempt cancelled by remote
• Doors unlocked, starter kill disarmed
• Exiting ignition valet
• Power ON to OFF (automatic transmission)
• Exiting remote valet
• Power-up reset
• Board set from manual to automatic; power
ON
2 slow flashes then
8 quick flashes
• Reset from manual to automatic
3
♦ Entering ignition valet
• Entering or exiting ready mode
• Entering remote valet
• Entering extended run time
4
• +12 V detected on the brake input wire
either while cranking or during run time
• Entering multi-speed tach programming
• Entering time delay adjustment in virtual
tach system
• Board set from automatic to manual; power
ON
• Power ON to OFF (manual transmission)
5 Fast
• Tach signal programmed
• New transmitter programmed
6 • A remote start was attempted while a tach-before-crank signal was detected before cranking
8 • Unit reset. See “Resetting the Module” (p. 2)
10
• A ground 0-) signal was detected on the hood pin input wire when attempting to remote start or
during run time
When pressing
START/STOP
15 quick flashes
• The parking brake is connected to ground (automatic transmission)
1 - pause - 2
• There was a remote start attempt while the vehicle was in valet mode
• Failed start: vehicle’s low battery voltage
ON SOLID for 3
seconds>.
^followed by 1 flash • Exiting cold weather mode
^followed by 3 flashes • Entering cold weather mode
ON continuously • Idle mode: Idle mode is engaged
• Run time: The vehicle has been remote started and is in run time
ON 2 seconds
• The hood has been opened and a ground (-) signal has been detected on the hood pin input
wire
ON 4 seconds • Locking or unlocking a door (with door pulses configured to 4 sec.)
ON 20 seconds • The hood pin has been flashed and you now have access to the programming options
Constant flashes
up to 60 sec.
• In siren or horn mode: Alarm condition generated by an intrusion, by panic mode or when the
system is powered up
http://www.autostart.ca Installation Guide
T W O - W A Y L C D
A U T O M A T I C / M A N U A l
T R A N S M I S S I O N
R E M O T E S T A R T E R W I T H F U L L A L A R M S Y S T E M
A N D V I R T U A L T A C H S Y S T E M
( A S P R G - 1 0 0 0 C O M P A T I B L E )
AS-6850vTW-FM
Quick Installation Guide
To obtain a copy of the installation guide, please visit the
http://www.autostart.ca website and click on the « Download » tab.
Table of Contents
How to Flash the Hood Pin..................................... 1
Manual or Automatic Transmission...................... 1
Resetting the Module...............................................2
Transmitter Programming Procedure.................... 2
Entering Programming Options............................. 2
Programming Options............................................. 2
Virtual Tach System.................................................6
Optional Time Delay Adjustment in Virtual
Tach System.................................................... 6
How to Flash the Hood Pin
Multi-speed Tach Programming............................. 6
Slren/Horn Honk Timing.......................................... 6
Supplementary Information.................................... 6
Fifth Relay Output (2nd IGN, ACC or CRANK).6
Tach jumper settings.......................................7
Testing...................................................................... 7
Diagnostics - Parking Light Flash Table............... 8
THE INSTALLER > THE MODULE >
• Press and hold the hood pin for 4 seconds.
• Release the hood pin (the parking lights will turn ON).
• While the parking lights are on, press the hood pin once more and
release immediately.
• You now have 20 seconds to select one of the sub-menus.
Parking Lights “ON”
“ON” for 20 seconds
Manual or Automatic Transmission
This module may be installed on vehicles with manual or automatic transmissions. It is originally configured for manual transmissions
although if the vehicle you are working on is automatic, it is mandatory to make a few quick and easy modifications before the unit is
connected. In the event that the TACH is learned and that the configuration requires changes afterwards, a complete reset will
be necessary before those changes become effective.
To install this unit in a vehicle with a manual transmission:
1. Make sure the Yellow loop on the PC board is connected.
2. Connect the Orange handbrake wire located on the 12-pin harness to the vehicle handbrake switch.
3. Connect the Blue/White (+) door input OR the Grey (-) door input wire located on the 12-pin harness to the vehicle door pin wire,
which monitors all the doors of the vehicle (only use 1 of the 2 door trigger inputs).
Notice
The manufacturer will accept no responsibility for any electrical damage resulting from improper installation of the product, be that either
damage to the vehicle itself or to the unit. This unit must be installed by a certified technician using all safety devices supplied. Please
note that this guide has been written for properly trained Autostart technicians: a certain level of skills and knowledge is therefore
assumed. Please review the installation guide carefully before beginning any work.
Warning
Before installing the unit, if installing on a vehicle with a manual transmission, test that the OEM Door Switch contacts of the vehicle work
well, and that the Parking Brake system operates properly. If installing on a vehicle with an automatic transmission, test that the vehicle
does not start when the gearshift lever is in the “Drive” position. If it starts in gear, install a manual transmission remote starter system
instead.
DOC: 1.00 ■ AS-6850vTW-FM ■ ■ November 8, 2007 ■ ■ MO ■ Assembled in Canada
P. 8