Avanti 494 VFYW - Manual (Page 15)

CHANGfNG REVERSIBLE DOOR
This refrigerator has been built wth the
door hinges on the right. If you wish to
change the opening direction, follow
instructions below.
1- Remove the upper rounded top (3).
Using a sharp object, pry out the 2 plug
buttons and remove the 2 Philips screws
(1). Remove the 2 Philips screws (2)
which connect the upper hinges to the
upper rounded top and place it on a
padded surface to prevent scratching.
2- Remove the bolts (4) of the upper
hinges. Careftjlly lift the door (5) and
place it on a padded surface to prevent
scratching.
3- Remove the levefing leg (6) from the
left side and transfer it to the right end {9}.
4- Remove the bottom hinge (7) from the
right side by unscrewing the two bolts
and transfer it to the left end (8).
5- Set the door {10} to Its place making
sure the hinge pin enters the bushing in
the door bottom section.
6- While- holding the door in the closed
position, loosely secure the upper hinges
(11) using the bolts removed in STEP 2.
7- Before tightening these bolts, make
sure the top of the door is level with the
cabined top. Avoid over- tightening these
bolts. Tighten both until they are just
snug, then turn another one-half turn.
8- Replace the upper rounded top (12),
9- Tighten the upper rounded top screws
(13) and press the plug buttons,
10- Fit and tighten the screws (14) which
connect the upper hinges to the upper
rounded top.
--I.: ' "i ■ ■ "
14