Signal generator, Ignal, Enerator – Audiovox SW-50 User Manual
Page 3: Nstallation, Scat speedometer cable into t, Gfineraror, After cable is assembled, insert, And install ^s, Nxrr, Assembly
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
,
S
ignal
G
enerator
K
it
#
250-4171
I
nstallation
I
nstructions
1. Remove Plaatlc Shipping Caps from Generator Components. Asaeitible Generator Components as
illustrated below. EXCEPT the •STAMPfio Nih
See Not« 1
2. You will need to work where the Vehicle Speedometer Cable is attached to the Transmission. If
necessary, raise the vehicle. Chock Wliecls,
WARNING
Do not get vndet any vehicle held up by a Jack only. Use Jack Stands or Ramps,
Tlic web of a concrete block will not bold the can DO NOT RISK YOUR UFBt
A. Disconnect Vehicle Speedometer Cable from Transmission.
B. Connect Speedometer Cable to T
ang
D
rive
A
dapter
, Scat Speedometer Cable into
T
ang
D
rive
A
dapter
Slot, tighten Speedometer Cable. See Note i
C.
Install Generator Assembly Into tiansmisslon housing. Turn
S
ignal
GfiNERAroR
so wires
wiD not catch on objects while driving. Tighten Nut.
TOEKISTINC
SPEEDOMETER
CABLE
NOTEl
After Cable Is assembled, insert
A
dapter
K
kt
Into other
end and rotate Drive Cable. If Cable wUl not rotate,
remove Tano
D
rive
A
dapter
and install ^S
tamped
Nxrr
(
5
/
8
-
18
}
In position shown. Reinstall
T
amg
D
rive
A
dapter
.
This will allow elearance between Speedometer Drive
Cable Inner Core Wire and
S
ignal
G
enerator
Assembly.
rml
2I№7
6/99 №
f
a