Clarion DRX9575Rz - Manual (Page 6)

10
DRX9575Rz
7. OPERATIONS
Basic Operations
Note: Be sure to read this chapter referring to the front diagrams of
chapter “3. CONTROLS” on page 5 (unfold).
CAUTION
Be sure to lower the volume before switching
off the unit power or the ignition key. The unit
remembers its last volume setting. If you
switch the power off with the volume up, when
you switch the power back on, the sudden
loud volume may hurt your hearing and dam-
age the unit.
The clock is displayed when the ignition key
is turned to the ACC (accessory) or IGN (igni-
tion-on) position even when the unit power
is off. In some cars, the clock may momen-
tarily disappear when the ignition key is
turned to the START position. The clock will
reappear after the engine has started and the
ignition key is released to the IGN (ignition-
on) position.
Turning on/off the power
Note:
• Be careful about using this unit for a long time with-
out running the engine. If you drain the car’s bat-
tery too far, you may not be able to start the en-
gine and this can reduce the service life of the
battery.
1. Press POWER button 5 .
2. The illumination and display on the unit light
up. The unit automatically remembers its last
operation mode and will automatically switch
to display that mode.
3. Press and hold POWER button 5 for 1 sec-
ond or longer to turn off the power for the unit.
Note:
• About the system check
The confirmation of connected equipments must
be performed for this unit only when the wiring
connection is complete and power is turned on to
the unit first. When the power is supplied,
“SYSTEM CHECK” appears in the display. Press
POWER button
5 . The system check starts inside
the unit. The equipments connected to this unit
appears in the display. Press POWER button
5
again.
Selecting a mode
1. Press FUNC button 5 to change the mode
of operation.
2. Each time you press FUNC button 5 , the
mode of operation changes in the following
order:
Radio mode ➜ CD mode ➜ CD changer mode
➜ MD changer mode ➜ TV mode ➜ Radio
mode...
∗
External equipment not connected with CeNET
is not selected.
Adjusting the volume
Turning the Rotary knob 3 clockwise increases
the volume; turning it counterclockwise de-
creases the volume.
∗
The volume level is from 00 (minimum) to 33 (maxi-
mum).
Switching the display
Press DISP button " to select the desired display.
Each time you press DISP button " , the display
switches in the following order:
Main display
Clock display
Spectrum analyzer display
Screen saver display
Main display...