ASA Electronics VOYAGER VOM-783T - Manual (Page 6)

VOM-783T OPERATIONS MANUAL
FUNCTIONS AND OPERATION
Front of Monitor : See FIGURE 4
1. Power switch : STAND- BY Monitor operates when vehicle transmission is switched into
"REVERSE" ON - monitor and system operate when ignition switch is "ON"
2. Camera selection : "CAT' used mainly for rear mounted camera or as specified by the installer.
"CA2" & "CA3" and used mainly for side or mirror mounted camera or as specified by the installer.
3. Tilt up/ down switch : Vertical angle or view adjusted into Up and Down positions.
4. Day/ Night switch : Pre-set brightness and contrast levels optimized for day or night operation.
5. Contrast : Variable control of contrast. Should be adjusted if the "DAY/ NIGHT"
switch does not achieve the most desirable picture.
6. Brightness : Variable control of brightness. Should be adjusted if the "DAY/ NIGHT"
switch does not achieve the most desirable picture.
7. Volume : Variable control of internal speaker volume and output audio level.
FUNCTIONS AND OPERATION CONTINUED
Rear of monitor : See FIGURE 4
8. POWER CONNECTION :
(6) (5^ (о) (6) (5) (4)
(3) (2) (О)
Pin No. Description
I Power ( DC lOV ~32V)
2 Trigger3 (DC 12V ~24V)
3 Ground
4 N/C
5 Trigger I (DC 12V~24V)
6 Trigger2 (DC 12V~ 24V)
VOM-783T 5