Avanti WC400YGB - Manual (Page 6)

Important Safety Instructions
WARNING/^
To reduce the risk of fire, electric shock,
or injury when using your wine cooler,
follow these basic precautions:
• Read all instructions before using the appliance.
• Child entrapment and suffocation are not problems of the past, Junked or
abandoned appliances are still dangerous... even if they will "just sit in
the garage a few days."
• Before you throw away your old refrigerator or wine cooler:
take off the door, leave the shelves in place, so that children may not
easily climb inside.
• Never allow children to operate, play with, or crawl inside the appliance.
• Never clean appliance parts with flammable fluids. The fumes can create
a fire hazard or explosion.
• Do not store or use gasoline or any other flammable vapors and liquids in
the vicinity of this or any other appliance. The fumes can create a fire or
explosion.
-Save these instructions-
INSTALLATION INSTRUCTIONS
^ Before Using Your Wine Cooler
• Remove the exterior and interior packing.
• Check to be sure the following parts are included:
- 6 slide out shelves
■ 1 Instruction manual
• Before connecting the appliance to the power source, let it stand
upright for approximately 2 hours. This will reduce the possibility of a
malfunction in the cooling system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
> Installation of Your Wine Cooler
• Place your appliance on a floor that is strong enough to support the
appliance when it is fully loaded. To level your appliance, adjust the
legs at the front of the appliance.
• Allow 5 inches of space between the back and sides of the appliance,
which allows the proper air circulation to cool the compressor.
• Locate the appliance away from direct sunlight and sources of heat
(stove, heater, radiator, etc.). Direct sunlight may affect the acrylic
coating and heat sources may increase electrical consumption.
Extreme cold ambient temperatures may also cause the appliance
not to perform properly.
• Avoid locating the appliance in moist areas. Too much moisture in the
air will cause frost to form quickly on the evaporator.
• Plug the appliance into an exclusive properly installed-grounded wall
outlet. Do not under any circumstances cut or remove the third
(ground) prong from the power cord. Any questions concerning power
and or grounding should be directed toward a certified electrician or
an authorized Avanti Products service center.
-5
-