Audiovox Cassette Player - Manual (Page 2)

CARE & MAINTENANCE
Always check that the tape is wound tightly inside the take-up spool on
the cassette. If the tape is loose, wind it with a six-sided pencil.
A. Never use C-120 style cassettes (120 minute cassettes) in this
player.
B. Never insert a cassette into your player when the vehicle
temperature is near or below freezing.
CLEANING OF TAPE HEAD & CAPSTAN
Since the tapes contain oxides, you will find black residue building up
on the tape head and drive capstan (inside cassette door). These
residues should be cleaned after 50 to 100 hours of accumulated tape
operation. You can either clean them by hand, with a cotton swab
slightly damp with alcohol (do not use any petroleum solvent) or a
commercial tape head cleaning solution available at most stereo
stores. Or you can use a special cleaning cassette (also available at
stereo stores) that automatically cleans the head and capstan when
inserted.
SPECIFICATIONS:
Size: 7” W X 2" H x4-1/2‘D
Operating Voltage:
178mm X 50mm x 115mm
12 volts DC, negative ground
Output Power: 14 watts maximum stereo power
Output Wiring:
(7 watts per channel)
Common ground type designed for 2
Output Impedance;
spieaker use. May also be used with 4
speakers.
Compatible with 4-8 ohm speakers
Tuning Range: (AM) 540-1,710 KHz
Sensitivity:
(FM) 88-108 MHz
(AM) Less that 15pV
FM Stereo Separation:
(FM) Less that 2.5 pV
30dB
Tape Frequency Response: 50-10,0OOHz
Wow & Fiutter: .25%
Tape S/N Ratio: 50dB standard tape
DEMAGNETIZING
The movement of the magnetic tape across the head and metal parts
of the tape player causes a magnetic field to develop. We recommend
you have the tape player demagnetized at least twice annually. You
can buy an inexpensive demagnetizing tool or have a stereo shop do
it for you.
r WHITE
r YELLOW
R . SPK
VIOLET-
TWIST jSf'
I—GREEN
INSULATE