Rear panel connections front panel controls – AMC 2N100-5 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
REAR PANEL CONNECTIONS FRONT PANEL CONTROLS
1. MAINS INLET
Connect the AC line cord in to the mains inlet
and plug the AC cord plug into a nearby wall
outlet that provides the correct AC power line
voltage.
2. INPUT LEVEL CONTROLS
Each channel of the 2N100-5/25100 has its own,
independent level control. Before turning on the
2N100-5/25100 for the first time, make sure that
all level controls are set to their fully clockwise
position. These controls can be used for various
functions. For example, they can be used to
match the levels of loudspeakers in a multi-room
installation, or to lower the sensitivity of the
power amplifier, so that the volume control on
pre-amplifier is at a more convenient and usable
position. They can also be used to optimise the
balance in a stereo system.
3. LINE OUTPUTS
Each input has an accompanying line output
which will pass the signal onto another amplifier
input or other line-level device.
4. LINE INPUTS
There are five RCA phono connectors on the
back panel that connect to the inputs of each of
the power amplifiers.
5. LOUDSPEAKER TERMINALS
The 2N100-5/25100 is equipped with binding
post type speaker terminals that are desiged to
handle the extremely high peak currents that this
amplifier is capable of giving. Connections from
these terminals to the loudspeakers should be
made with heavy-duty wire. Standard wire of 16
gauge or thicker is recommended especially if
low impedance loudspeakers are used.
1. POWER SWITCH
The press button switch marked power can be
used to switch the 2N100-5/25100 on or off.
When the 2N100-5/25100 is switched on, the
small indicator above the power switch will glow
green.